This How-to is for informational purposes only. I'm not responsible if you break something.
Wheel Bearing and Wheel Hub
Removal and Installation
1. If equipped, turn the air suspension switch to the OFF position.
2. Remove the wheel.
3.
NOTE: Have an assistant press the brake pedal to keep the axle from rotating.
-Remove and discard the rear axle wheel hub retainer and the washer.
4. Using a suitable hub puller, separate the outboard CV joint from the wheel hub.
5.
CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can result.
- Remove the bolts, and position the caliper, pads and anchor plate aside.
6. Remove the brake disc.
7. Disconnect the wheel speed sensor electrical connector and detach the retainer.
8. Remove the bolt and detach the retainers.
9. Remove the bolts, the wheel bearing and the wheel speed sensor as an assembly.
-Route the sensor wiring through the access hole in the brake shield.
-Discard the bolts.
10. To install, reverse the removal procedure.