Help od light flashing

[Ogbign]

2000 expedition 5.4 2we someone cutt a set of wires that runs along the outside of the frame rail just below the driver door. I've wired the wires back but only fixed a few issues like fuel gauge is now working again. It was throwing a lot of codes before only a few went away. An od light still flashing ! Any help ?? Any1 know what all those wires work ?

 

[Bedrck47]

Welcome to the forum.

Saying that is was throwing codes tells us nothing but if you post the codes the we can look them up and offer help.

help that you will received is based on information you provide

 

[Ogbign]

All the codes are circuit codes. I need to know what that set of wires goto.
Before i found the cut wires
My gas gaauge wasnt working an it threw all these codes.
P0743, *P0750, p0755, p1747, *p0453, *p0443, p1451, p0135
*p0141, p0155, *p0161, p1409
I put a star next to the codes that went away after fixing the set of wires that wer cut. I kmow what the codes are. I just dont no if my comp. fried or more wires cut, or ???

 

[Bedrck47]

I would strongly suggest that you get a copy of the Ford Service Manual on DVD It has complete wiring diagrams and is specific to your year and model

http://www.expeditionforum.com/threads/factory-service-manuals.25089/

 

[Ogbign]

The truck will drive, but od light is flashing an it dosent want to move from a stop. It acts like its trying to take off in 2nd or 3rd. An i have to manualy shift it. Ive cleared all the codes an they come rite bak.

 

[Ogbign]

I orederd a haynes reapair manual but dosent help much

 

[Bedrck47]

P0743
Torque Converter Clutch System Electrical

P0755
Shift Solenoid B Malfunction

P1747
Pressure Control Solenoid A Short Circuit

P1451
Evaporative Emissions System Vent Control Valve Circuit Malfunction

P0135
Oxygen Sensor Heater Bank 1 Sensor 1

Could not get any information as of yet on P0155 or P1409

 

[Bedrck47]

Any of the aftermarket manuals are only good for starting campfires The ford manual is a factory manual and is specific to your year and model

 

[Bedrck47]

deleted

 

[Ogbign]

P0155 is o2 sensor bank2 sensor 1 an p1409 os egr vaccum regulator solinoid circuit, is that what transmission thats in mine 4r100 ???

 

[Bedrck47]

I was trying to post a print just for you to see what the factory print looks like

Take your vin number and go to ford etis and enter the vin it will give you a readout of all that was on the expy as built Let me know what trans you have. Or you can look at the label by the divers door and get the trans code.

 

[Bedrck47]

Being you have a harness that has been cut You can see how many wires are involved and also get the color code on the wires.

Now the problem comes in that you could have some wires that have the same color code but by knowing what systems are bad you can look at the connectors for that circuit and trace the wires using an ohm meter

 

[Ogbign]

if i cud find out what all the wires go to that they cut that would help me alot.

 

[Ogbign]

It says tr E

 

[Bedrck47]

Totally understand But you could spend many hours trying to figure it out Again knowing what systems have been affected and having the correct wiring diagrams will make tracing those wires much easier Although very time consuming

What would help is if you can post the number of wires in that harness and the color of the wires Some may be solid colors and some will have two colors on them for example Red with a white stripe or white with a red stripe The stripe will be the smaller of the colors

 

[Ogbign]

E4od (4r100)

 

[Ogbign]

Ok i can do that,

 

[Bedrck47]

Trans is
4R100 or also known as E40D

 

[Bedrck47]

Wiring diagram

 

[Bedrck47]

If you look at the above print you will see the trans with a connector C193 That shows the wires and the location at the connector those wires go back to the PCM C174 but they also go thru C172 If you know the locations of those connectors and the pin numbers involved you would be able to check the for continuity.