misfire on 2003 expedion
- Thread starter jarbbie
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
01yellerCobra
Full Access Members
Calm down. It's late and not everyone is up and on forums.
When was the last time the plugs were changed?
Misspelling brought to you by tapatalk
When was the last time the plugs were changed?
Misspelling brought to you by tapatalk
B
bedrck46
The following was copied from the Ford workshop manual
DTC
P0351 Through P0360 - Ignition Coil A through J Primary/Secondary Circuit Malfunction
Description
Each ignition primary circuit is continuously monitored. The test fails when the PCM does not receive a valid IDM pulse signal from the ignition module (integrated in PCM).
Possible Causes
Open or short in Ignition START/RUN circuit
Open coil driver circuit in harness
Coil driver circuit shorted to ground
Damaged coil
Damaged PCM
Coil driver circuit shorted to PWR
DTC
P0351 Through P0360 - Ignition Coil A through J Primary/Secondary Circuit Malfunction
Description
Each ignition primary circuit is continuously monitored. The test fails when the PCM does not receive a valid IDM pulse signal from the ignition module (integrated in PCM).
Possible Causes
Open or short in Ignition START/RUN circuit
Open coil driver circuit in harness
Coil driver circuit shorted to ground
Damaged coil
Damaged PCM
Coil driver circuit shorted to PWR
jdecker
Well-Known Member
replace your coils and plugs
Butch Smith
Full Access Members
Go to a parts store and find out which coil is miss firing. then replace that coil.
01yellerCobra
Full Access Members
Going by his post 4, 5, 6, and 8 are missing. More then likely the plugs are toast.
Misspelling brought to you by tapatalk
Misspelling brought to you by tapatalk
Similar threads
