Robert McMillan
17plati
I have a 16 platinum EL and a 16 Limited SWB. Both have full LED Conversions and I used Forscan to disable hyperflash on bothWhat year is your Expy and did you add a resistor? Those are my last questions.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I have a 16 platinum EL and a 16 Limited SWB. Both have full LED Conversions and I used Forscan to disable hyperflash on bothWhat year is your Expy and did you add a resistor? Those are my last questions.
I disabled hyperflash in 8 minutes and drank a beerAdding resistors are as easy as replacing bulbs. All my 2011 Expy signals are LED and with resistors. Did them all in 1 hour.
I never could figure out why everybody keeps messing with them anyway when the stock ones are fully adequate.I added the LEDs to the rear turn signals. No hyperflash during the day. I just learned that they behave differently at night - hyperflash. Bummer.
Back to Amazon they will go and back in go the incandescent bulbs. Not worth anymore of my time.
I never could figure out why everybody keeps messing with them anyway when the stock ones are fully adequate.
Bc LED are superior to ****** halogen. Have you tried LED lows or highs on your truck? Doubt it, LED is a far superior difference than halogenI never could figure out why everybody keeps messing with them anyway when the stock ones are fully adequate.
I can't figure why you would harass someone from behind a keyboard that you don't even know. I try to help people but most are too naïve to grasp good advice.I could never figure out why you ***** so much about what other people do to their cars.
Take a look at the picture in my initial post. The incandescent bulbs were literally burning up the sockets. I wanted LEDs because they run cooler while producing the same or slightly higher level of brightness. Resistors generate heat which is what I was trying eliminate in the first place.I never could figure out why everybody keeps messing with them anyway when the stock ones are fully adequate.
Yeah I've seen resistors burn through wiring harnesses and plastic parts of the head/tail light housings. Not goodTake a look at the picture in my initial post. The incandescent bulbs were literally burning up the sockets. I wanted LEDs because they run cooler while producing the same or slightly higher level of brightness. Resistors generate heat which is what I was trying eliminate in the first place.