What do you need to do to add a key pad door handle?

[tb3375]

I have a 1997 Eddie Bauer XLT. I have a lincoln navigator door key pad handle that I got from the junkyard. I cut all the wire I believe I need. The only thing I think I may have for gotten was a computer chip or a fuse of etc.. Has anyone ever tried this before and if so what is my next step to install it. I know I'm going to need to tap into the wiring, but what else will I need to do? Thank you

 

[walnuts4x4]

http://www.fordf150.net/howto/keypad1.php

http://www.fordf150.net/howto/keypad2.php

here ya go

 

[tb3375]

Thank you for the info!

Do you believe the alarm box is the same or would I need to go get the Navigator one?

Thanks again

 

[walnuts4x4]

i dont know exactly with a navi setup but my computer also know as a RAP module came out of my mothers taurus when she was trading it in during cash for clunkers.... my rap just died so I swapped them out... look under dash its a small white box mine was to the left of break pedal way up under dash...

 

[tb3375]

I went back to the junkyard and got the wire harness. I saw the white box in a junk Eddie and a junk navigator. They both were the same so I didn't take the time to look at mine. I have a 4x4 Eddie 97. When I got home and went to install it the box was black and the plug-ins were two different sizes, plus the black box has some kind of antenna coming out of it?

Thanks for the help.

 

[walnuts4x4]

not sure of the black box... maybe remote start?... but the RAP should be white (usually) and it will have a 5 digit number on it... that will be the code for the keyless entry