Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
As I was looking over the pictures that Natalie from WAM sent me I was reminded of a picture that I saw of another Expedition with the same bumper...
View attachment 19565
I didn't like how the ends of the bumper, where it wraps around the side of the vehicle, were open... having the thin edge of the sheet metal exposed. So I shot a note to Natalie along with a picture of what I was thinking... sheet metal welded to the very end of the bumper so that it's essentially closed off.
View attachment 19562
Is it my imagination or did the rear wheels come forward a bit? The control arms are at an angle, rotated towards the back. With the lift the wheels may get sucked forward a bit. Or maybe it's just more noticeable because the wheel wells sit up higher?
I believe thats an alignment spec called caster