ynpmoose
Well-Known Member
I have a non-Nav Sync 3 system that I previously successfully upgraded from 1.0 to 2.2. Now, I downloaded the official 2.3 update from Ford. Followed all the instructions: formatted 32GB flash as exFAT, unzipped, etc. I kept getting MEM_ERR03 error.
I found a post somewhere else that explained splitting the install, so I did that. The first part of the install was now successful and the system shows as updated. But the second part still fails with the same error. This second install is only trying to install the voice command data:
My autoinstall.lst for the second install contains only this:
Any suggestions are appreciated.
I found a post somewhere else that explained splitting the install, so I did that. The first part of the install was now successful and the system shows as updated. But the second part still fails with the same error. This second install is only trying to install the voice command data:
JL7T-14G391-BB.tar.gz - 1.1Gb
My autoinstall.lst for the second install contains only this:
[SYNCGen3.0_ALL]
Item1 = JL7T-14G391-BB
Open1 = SyncMyRide\JL7T-14G391-BB.tar.gz
Options = AutoInstall
Item1 = JL7T-14G391-BB
Open1 = SyncMyRide\JL7T-14G391-BB.tar.gz
Options = AutoInstall
Any suggestions are appreciated.