Recent content by Am3gross

  1. A

    low miles vs hi miles( well cared for)

    A lot of people have expys with a lot of miles on them, do a search and you will see.. I would take well taken care of over a new car any day, and I do, I have a 2013 mustang that just sits in the drive, while I drive my expedition.. I didn't know much about my expy when I bought it honestly. I...
  2. A

    Spark plug change... my wallet hurts

    Hope she runs better.....
  3. A

    What did you do to the expy today

    Been a busy few weeks for me, I have changed both front upper control arms, with new upper ball joints, new brakes on all for corners, new parking brake pads, flushed the old brake fluid out and put fresh in, 4 new Firestone tires, a 4 wheel alignment, a clock spring to get rid of the air bag...
  4. A

    water in tail lights?

    That's funny right there!
  5. A

    Wiggly COP?

    I had that issue. .. I kept tighten until that basted broke. .. don't do that.... I think you will be ok. I have 2 not being held on by anything. At least you have a screw in yours.
  6. A

    water in tail lights?

    Just on the drivers side..... no holes anywhere and all the screws are there. . I figure I will be buying a new one soon... just not high on my priority list right now. I did drill two holes in the back of the assembly where the water was sitting, im thinking that for now it should keep the...
  7. A

    water in tail lights?

    I am getting water in my tail lights, how do you fix this? New tail light? Change the little seal around the light socket?
  8. A

    air bag light

    As far as the airbag goes do you hear any kind of noise coming from the steering column. Kinda like it needs lubed? May be a clock spring for the light
  9. A

    1st time for me

    Mine did the same thing, every couple weeks I usually throw a socket and wrench in there just to make sure it's still tight... Should be fine, u will just have to keep an eye on it
  10. A

    Spark Plug Removal Issue

    Are u using the socket with the black rubber deal in there, I always have one socket with out that piece in there,
  11. A

    Just a sigh of release....

    I'm in hampton
  12. A

    Just a sigh of release....

    So today's plans was to change out the two upper control arms because I had a bad ball joint... I figure if you change one, you should probably change the other... So I did... Didn't really plan to take the front shock struts out but I guess you have to do what you got to do.... I also changed...
  13. A

    Hellppp please

    So.... U hooked up a trailer, and the turn signal was not working..... I did that with my camper once, the connector I plugged into the plug was not making good contact. I wiggled the plug and it started working as it should... As far as the spitting and sputtering, again I assume with the...
  14. A

    Hello

    Hello, I am sure you issues will be addressed! This is a great site! Lots of helpful members.
  15. A

    Hellppp please

    Are you getting a cel?
See more

Latest posts

Members online

Total: 928 (members: 1, guests: 927)

Forum statistics

Threads
53,696
Posts
503,110
Members
47,344
Latest member
jmdunham2

Share this page

Top