Recent content by scurvydog
-
S
HVAC fan dies at full speed.
Well it was the resistor. Quick order of the part off amazon solved the day. I will say looking through the service manual there was a section on testing the resistor with an ohm meter but, none of the results that I got were consistent with the service manual.- scurvydog
- Post #22
- Forum: 3rd Gen - 2007 - 2017
-
S
HVAC fan dies at full speed.
I can say from my experience it is very likely some think like the resistor as it operates 100% reliable to 90% fan speed. Once I over ride the automatic temp control to 100% it cuts within 1 second. Restart the vehicle fan works immediately. So not a mechanical I would say. I just did not know...- scurvydog
- Post #14
- Forum: 3rd Gen - 2007 - 2017
-
S
HVAC fan dies at full speed.
So I have have both the Auto button with up/down buttons to set temperature as well as a fan speed +/- button on the dash. So it looks like I just need to grab one of the OEM with auto temp control on the link above.- scurvydog
- Post #4
- Forum: 3rd Gen - 2007 - 2017
-
S
HVAC fan dies at full speed.
Hello, I have a 2008 Expedition and the issue I have is with the fan for the heat/ac. When the fan speed control is changed to max the fan will cut out after a few seconds. Keep the speed one notch below max and everything works fine. A restart of the vehicle will get the fan motor working...- scurvydog
- Thread
- Replies: 21
- Forum: 3rd Gen - 2007 - 2017
-
S
Water Leak Drivers Side '08 XLT
Hello, I just started having a water leak by the front drivers side door. I noticed a wet spot on the floor right next to the door sill between the bottom of the a-pillar and the seat. There was also water sometimes on the plastic door sill itself when I would open the door which I found...- scurvydog
- Thread
- Replies: 4
- Forum: 3rd Gen - 2007 - 2017
-
S
Heated / Cooled seat Problem
Has anyone who had this problem gotten it resolved? I have the same thing that started up in my '08 Expedition EL. Curious to know before I have to bring it into a dealer. Thanks- scurvydog
- Post #19
- Forum: Electrical
