fuzzmanmatt
Full Access Members
I finally got fed up with hauling around a 55 gallon tote of crap for search and rescue stuff that I carry, so I pulled out the third row of seats and built a little box to shove everything into. 2007 Eddie Bauer Standard wheelbase. The box ended up being about 4'x4', give or take an inch each way.
Basic Frame:
Final Boxed Frame - The wood in the middle is about where the back end drops off into the floor pan for the front of the truck.
It's attached to the body using the mounts where the spare tire holder trim was.
And with the 3/4" plywood on the top, it doesn't look too bad!
I have the plywood cut at 18" from the front, I have to get a piano hinge to attach it to the frame, and I'll put a lip in where the cross support is to latch into everything and keep it closed, and another hinge will be mounted there for the rest of the lid. I'll update once I get that all done. If I get ambitious, I might put in lift supports for the lids, but that's far down the line. I'm also trying to decide if I want to do a rubber flooring on the top, or a painted/roll on bedliner.
Basic Frame:
Final Boxed Frame - The wood in the middle is about where the back end drops off into the floor pan for the front of the truck.
It's attached to the body using the mounts where the spare tire holder trim was.
And with the 3/4" plywood on the top, it doesn't look too bad!
I have the plywood cut at 18" from the front, I have to get a piano hinge to attach it to the frame, and I'll put a lip in where the cross support is to latch into everything and keep it closed, and another hinge will be mounted there for the rest of the lid. I'll update once I get that all done. If I get ambitious, I might put in lift supports for the lids, but that's far down the line. I'm also trying to decide if I want to do a rubber flooring on the top, or a painted/roll on bedliner.
Last edited: