2000 Expedition: Need electrical help for two wires in main harness

[chucky2]

I've soldered pretty much every wire from a donor harness to my dads 2000 Expedition Eddie Bauer 4x4...it just so happens the last two wires turned out to be exactly the same color, same gauge, and are in the same trunk going to the back of the vehicle in the second row.


They're pins 1 and 3 in the connector picture (attached), orange w/ green stripe.


Does anyone have a wiring schematic or something that would let me know where these end up, so I can get a tone on at least one wire and figure out which is which before I solder to the donor connector?


Much thanks for any help here!

 

[stamp11127]

Need to know which connector you are talking about since there a few of them back there.
Diagrams attached.

 

[chucky2]

EDIT: In your first attachment, this connector is in the location C285 and C286 on the left side labels. In your second attachment, it's in the C270 location, also left side labels. All three point to the passenger footwell. That's where all the connectors for the main wiring harness congregate. None of them are labeled so I don't know what any of them are for.

Thank you much for helping!

 

[chucky2]

It probably would have happened here, but, it looks like I've got my answer on a duplicate thread I started on another site. If anyone else runs into this problem, the thread below is where alloro on Ford Truck Enthusiasts was able to solve my problem:

2000 Expedition: Need electrical help for two wires in main harness - Ford Truck Enthusiasts Forums

stamp11127 thank you for your help! I'm betting what he posted up was probably what you were going to share later.