2nd amp install

[GAINMOB]

what up folks!!! straight 2 da point...i'm wanting 2 amp-up my door speakers so i can hear more music/words without having to turn my bass down...i can only do a simple 1-amp install and change head units...NOTHING MORE...NOTHING LESS...with my limited experience is it possible to complete a 2nd amp install or is it more complicated? please advise

currently running 5x7 or 6x8 (07 model) kickers and 2-12 inch kicker cvr's with ma audio 1200 rms mono

also...how difficult is to add tweets?

 

[WHOISMOOTOO]

DEPENDS ON YOUR HEADUNIT IF YOU HAVE AFTERMARKET ITS A PIECE OF CAKE RUN NEW RCA'S FROM THE DECK (DOOR SPEAKER OUTPUTS) ALLONG SIDE YOUR RCA'S TO YOUR SUB AMP (IF YOUR MOUNTING YOUR AMP IN THE SAME LOCATION AS YOUR BASS AMP) THEN RUN NEW POWER WIRE FROM THE BATT AND IF YOU WANT YOU CAN "DAISY CHAIN" THE REMOTE WIRE FROM ONE TO THE OTHER. NOW THE HARD PART IS RUNNING THE SPEAKER WIRE TO THE DOORS AND GETTING THEM THRU THE HOSE THAT ALL THE FACTORY WIRES ARE IN CONNECT TO THE SPEAKER THEN BOOM BABY BOOM YOUR DONE! PRETTY SIMPLE PROCESS. JUST LIKE SUBS MAKE SURE YOUR NOT UNDER/OVER POWERING WHEN YOU MATCH UP SPEAKER AND AMPS IM GOING WITH THE KENWOOD 6X8 IN THE BACK AND 5X7 IN THE FRONT WITH A 60X4 AMP SETUP (most cose effective in my opinion)

 

[GAINMOB]

sounds easy enough...i may just do it...if all else fails...i'll get it done (last resort)

 

[Chrismdean09]

speakers

I would try to run 6 3/4 round speakers tend to sound better with out distorting Pioneer is what I use and I run two 15's tuned to 29 hrtz at 1500rms

 

[GAINMOB]

i'll get my system redone in about 2yrs and will do component rounds at that time...right now i'll working on laying new wire with distro blocks...for the power and ground and make do with what i have for now...