SkylinePCG
New Member
2000 Expedition, 100k miles, just picked it up over the summer, and after swapping out the air bags, rebuilding the front end, and adding some E-load 285s, we're heading inthe right direction.
Currently Im trying to tackle the ABS problem. Yesterday I got into it, and found that below the module, theres a pair of wires- harnessed at one end, going into the module, separated at the other, and attaching to the pump- theyve completely corroded; one was dust, the other barely hanging on.
Now being that the leads are gone (GONE!) whats the best way to go about getting these wires communicating again?
Soldering looks like it would be difficult if even possible.
Id like to not disconnect all the master cylinder lines-dont know that theyd want to come apart if I tried.
Does the pump come apart in multiple pieces?
Or am I just going to have to make the mess, and introduce air to the system...
Thanks in advance!
Currently Im trying to tackle the ABS problem. Yesterday I got into it, and found that below the module, theres a pair of wires- harnessed at one end, going into the module, separated at the other, and attaching to the pump- theyve completely corroded; one was dust, the other barely hanging on.
Now being that the leads are gone (GONE!) whats the best way to go about getting these wires communicating again?
Soldering looks like it would be difficult if even possible.
Id like to not disconnect all the master cylinder lines-dont know that theyd want to come apart if I tried.
Does the pump come apart in multiple pieces?
Or am I just going to have to make the mess, and introduce air to the system...
Thanks in advance!
