Buzz1132
New Member
I have a 2004 Expedition. I checked all four backup sensors and they are clicking when I check them in reverse with the ignition set to on. The stereo lowers, but there's no beeping sound indicating proximity. Any suggestions?
Backup Sensor issue
- Thread starter Buzz1132
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Bedrck47
Full Access Members
Are you the original owner?
If not is it possible that the speaker has been disconnected or silenced?
Also check the setup in the message center to see if the speaker has been disabled.
If not is it possible that the speaker has been disconnected or silenced?
Also check the setup in the message center to see if the speaker has been disabled.
Buzz1132
New Member
Yes I am the original owner. I will check the speaker. Would you know where that is. Thanks for the first reply!
Bedrck47
Full Access Members
atop rear wheelwell drivers side
Bedrck47
Full Access Members
the attached print is for the 03 model the 04 is the same You may be able to gain access by removing the tray above the connectors.
Buzz1132
New Member
Thanks for your help. I found it. It has the speaker attached to the module. I might have to replace the entire module because I can't find the speaker that is sold separately. Thanks again for your help!
