Had my FX4 blacked out..Hated looking at the chrome and silver trim.
Sent from my iPhone using Tapatalk
Looks great. Painted the grill or wrapped?
What Have You Done to Your 4th Gen This Week?
- Thread starter MATT0404
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Looks great. Painted the grill or wrapped?
StealthyBulldog
Full Access Members
Looks great! I was thinking of doing that chrome strip, once again, why they would put the chrome strip on a Stealth pkg that already has the rear blacked out is beyond me!
Mine wasn't a Stealth.. but it's wrapped now and looks like one.
Sent from my iPhone using Tapatalk
StealthyBulldog
Full Access Members
Sorry, I mean that mine is a Stealth and the chrome bothered me from day 1. On my pontoon forum they have a black anodized rails and it looks super sharp! Definitely like yours! Is it a gloss wrap or flat?
Lou Hamilton
Full Access Members
What wheel and tire size?
What lift are you using? Any issues that you can report?
Good looking Expy!
Looks great. Might as well just totally remove the air dam. Couldn't be easier & and you won't miss it.
Thanks. I thought about removing it. It was off when I was trimming it. But there were a few connectors that I thought were helping hold some other trim pieces in place. I should check again. Thanks for the comments.
Rancidlunchmeat
2019 XLT FX4
What tires and wheels are you running?
sjwhiteley
Full Access Members
Added Setina pusher bar, finished mounting the Raptor front skid plate and roof rails.
Last edited:
Looks very cool. How long did it take to install? And does it affect the front parking sensors at all?
Sent from my iPhone using Tapatalk
sjwhiteley
Full Access Members
I don’t have front parking sensors. However, the instructions say it is not compatible with the front parking sensors, collision detection and adaptive cruise control.
I don’t know why it’s not compatible with the latter until I took off the front bumper: there’s a radar (?) module on the front passenger side, where one of the mounting brackets goes. I don’t know what it does but I tie wrapped it back in place. We will see what happens, since the pusher bar is in front of that sensor.
edit: took around 4 hours, but I’m not quick at doing this sort of stuff. It does include cutting holes in the plastic of the front grille for the upper mounts.
Last edited:
Lou Hamilton
Full Access Members
Here's one. Just got hit by a lady...
Other than the scratches, my windshield washer fluid must have somehow got punctured because it all leaked out.
Other than the scratches, my windshield washer fluid must have somehow got punctured because it all leaked out.
Your car wet it’s pants from getting hit... I’ve heard of this happening.
Sucks about the fender bender though, cops and all that or just exchanging insurance?
Lou Hamilton
Full Access Members
She said that she did not have her insurance card on her, so I got the cops involved. She just wanted to exchange phone numbers and then call me when she got home... yeah, right.
Cops came and was able to pull her insurance for me. I have a documented report that the insurance can reference. We have the same insurance company and I have dash cam footage. I think they will find her at fault. Fingers crossed.
bushpilot
Full Access Members
Ceramic coated....Clear bra on the entire front clip (front bumper, hood and fenders completely covered), 5% Tint on all glass behind the front doors, 15% on the front doors....OH and had the rear B pillar wrapped in black!
Before & After....
Before & After....
Last edited:
I got to install my dashcam!!!
Similar threads
