Recent content by splintrcel

  1. splintrcel

    2001 EB 4r100 trans hum after fluid swap

    I dropped my trans pan and replaced the fluid with Mercon Valvoline fluid. There wasn't anything dirty in the pan and I cleaned it out well before I put it back. I checked my fluid level on the trans and it is a little on the high end of the hot fluid level zone. it started making a hum that...
  2. splintrcel

    Place to tap a relay into.

    Thanks guys, i bought a bunch of the good connectors and shrink wrap already. The blue connectors are the worst. I will post once I get it set up this winter.
  3. splintrcel

    Place to tap a relay into.

    I am looking to add an auxiliary fuse block for powering accessories and I plan to run power from the battery to power it however I would like the block to only have power when the truck is on via a relay. I have a 1st gen EB. Anyone know a good spot to tap a line that only is hot when the car...
  4. splintrcel

    procedure for lining up rear trailing arms

    I had a rusted out trailing arm as well. Placing the jack stands under the frame is the best spot but i threw two just under the axle as an extra messure. They were not acutally touching the axle but there for a peace of mind.
  5. splintrcel

    Stuck Rotors

    I had this happen to one of my front rotors. There are certain things you have to do before a project can be completed. Sacrifices must be made to the car gods in the form of cursing before anything will get done. The more cursing the better. That or a mapp gas torch is your best friend...
  6. splintrcel

    Keyless entry stopped responding to key fob

    I will check over my remotes again and it is possible i have a leaky windshield. The seal has some chips in it and is probably 5 years old or more. I will have to dive under the dash. Thanks guys
  7. splintrcel

    Keyless entry stopped responding to key fob

    My 2001 EB no longer responds to any of my key fobs (2 are brand new). The problem started at least a year a go when it took multiple times of me hitting the buttons to get it to respond and as time progresses it responded less and less. I swapped batteries in the remote and reprogrammed my...
  8. splintrcel

    Child safety locks

    Its a common issue with the first generation expeditions where the safety locks get stuck in the locked position. Its a really easy fix. All you need is a can of WD-40. Spray the WD-40 into the lock switch and move the switch up and down several times to get the WD-40 worked into the system...
  9. splintrcel

    "vista pro" heater core from rock auto, anyone here have any bad/good experience?

    All i am gonna say is buy the nicest heater core you can get so you only have to do it once. Pulling a dash isn't hard, its just really time consuming and there are some tight spaces but its very doable. Also make sure you have the correct quick disconnect coolant line tools. Its damn near...
  10. splintrcel

    Infamous Leaking Intake Gasket

    I swapped the gasket using only the internet and my young energy and got it done in a weekend. My only mistake was i misunderstood that left on the gasket meant left when your sitting in the drivers seat, not looking at the engine so you could say i changed my intake manifold gasket twice. Go...
  11. splintrcel

    2000 Mi one way road trip

    So I will be making a trip in a few months using my 2001 EB expy 5.4 AWD with tow package to go from Platteville WI to Portland Oregon which is more or less 2000 miles one way and i have to bring a trailer that hasn't been decided on. Anyone have any suggestions to go about making this journey...
  12. splintrcel

    No start

    Right as i typed this i had a sudden realization of a similar issue one of my friends had where the gear shifter was slightly out of alignment where the indicator for what gear was selected said it was in park but it was a little shifted towards neutral so the car would start because the sensors...
  13. splintrcel

    No start

    I couldn't start my truck this morning, my battery is reading 12 volts and all the internal systems are operating. When i turn my key to ignition nothing happens at all, not even a click. I replaced the starter relay on the fire wall and still nothing happens. If i jump the terminals of the...
  14. splintrcel

    Rear axle bent lower shock mount Driver side

    What kind of blade did you use to cut the shock, i was thinking about cutting up the shock as a last ditch effort. Thanks for the info though, i am glad i am able to salvage the mount. I will make an attempt again sood on this project.
  15. splintrcel

    Rear axle bent lower shock mount Driver side

    So upon much frustration of trying to get my lower shock absorber removed, i realized the reason the lower bolt will not come out is because the lower mount is bent ever so slightly so the bolt it self is bent. Anyone run into this issue because i am slightly frustrated. I am thinking drilling...
See more

Latest posts

Members online

Total: 1,713 (members: 20, guests: 1,693)

Forum statistics

Threads
53,585
Posts
502,202
Members
47,161
Latest member
M Bennett

Share this page

Top