Powerstroke045
New Member
Hey guys, I have a 2011 expedition limited. The power running board on the driver side will stay out when the vehicle is off. Turn the vehicle on and close the door the running board works as it should. Any ideas?
2011 limited power running boards problem
- Thread starter Powerstroke045
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
When the truck is off does the board try to retract and then go back down? Mine did that for a while. I figured the extra voltage from the engine being on was enough to get it to retract.
I cleaned off the hinges with some WD40 and haven't had any problems since then
I cleaned off the hinges with some WD40 and haven't had any problems since then
star-art
Full Access Members
The steps are controlled by a PRB module. If there is no mechanical obstruction or binding, any "misbehavior" is being caused by the module and needs to be diagnosed that way.
