Click, click, click..wtef?

[Explor2Exped]

in the red. check that out. replace it and the elbow. should solve your problems. its under the hoses. a little hard to get to, but you can move the hoses a bit and it comes right up.

Here is that piece in the red pulled out. There is no cracks in the rubber but the metal piece is filthy dirty...

 

[Explor2Exped]

Should I clean out all those debris or is that there to keep it lubricated?

Should I just buy a new one? they are only $3

 

[panda24619]

buy it. and the elbow. see. i knew what i was talking about. haha cost might be $20 total.

 

[Explor2Exped]

buy it. and the elbow. see. i knew what i was talking about. haha cost might be $20 total.

I bought it & the guy at the auto store also recommended buying a brand new mass air flow sensor which is 69.99 & 45.99 deposit. I can't afford that right now so I just bought some cleaner.

Ughhhhhhh this is so frustrating cause the light is still on...

 

[panda24619]

did you buy the elbow in the back as well? and dont get a new maf. cause if you needed a new one your engine would run like CRAPOLA! it would hardly move.

 

[Explor2Exped]

did you buy the elbow in the back as well? and dont get a new maf. cause if you needed a new one your engine would run like CRAPOLA! it would hardly move.

Now this is what I don't understand... Those two codes that popped up & the way most people have said to fix it deals with the way the engine idles. By my truck idles fine around 700rpms, besides that random clicking & the quiet fast pace clicking.

I dunno............

CELs piss me off, hah...

 

[walnuts4x4]

is it still running bad or just the CEL... might wanna try disconnecting the battery for a few minutes to reset the CEL and see if they clear it...

 

[Explor2Exped]

is it still running bad or just the CEL... might wanna try disconnecting the battery for a few minutes to reset the CEL and see if they clear it...

I'll try that & when I find my cam I'll take a video of how it's running.

I've never had this much trouble getting rid of some codes...

 

[panda24619]

thats sooo weird. it has to be a vacuum leak of some sort...

 

[Explor2Exped]

is it still running bad or just the CEL... might wanna try disconnecting the battery for a few minutes to reset the CEL and see if they clear it...

I disconnected the battery for 15 mins & the CEL is now gone. It shows when I click it over though & doesn't go out but when I start it up it clears out.

Hopefully after a drive cycle it still stays off.

Thanks walnuts!