Disabling 'Check Suspension' alarm on 2003 Expy

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

alexwasserman

Full Access Members
Joined
May 9, 2010
Posts
69
Reaction score
2
Location
NJ
Hi all,

I'm not sure if this belongs in here, or in the electronics forum, but here goes.

I have an '03 Expy that came with the air suspension already converted to normal shocks. The switch is turned off to disable the air suspension, it came that way, and I was told by the shop to leave it off. However, that always triggers the 'Check Suspension' message on the console.

I've seen on other posts for earlier models that you can remove the bulb for the light, but in this case it's part of the information computer display, there isn't a bulb to remove.

How can I bypass that warning?

Thanks,

Alex
 

GAINMOB

Full Access Members
Joined
May 19, 2010
Posts
14,565
Reaction score
893
Location
Newport News, VA
for the tire sensor...put your old ones in your tires and any tires shop can recalculate and prob will be solved...i put my factory sensors in my 24's...rim shop recalculated and sensor is good...
 

ShawnT2142

Member
Joined
May 9, 2012
Posts
21
Reaction score
0
Location
Pennsylvania
i got rid of the check suspension light by pulling the fuse. until i found out that this fuse also ran the power from my 4x4 knob to the transfer case... so if you will never use 4x4, then pull the fuse (save it of course) and if you need to use it then you can throw it back in. when you do this though, obviously pull the cable for the battery to reset the computer and there ya go.

^this is the jerry rigged way.
 
Top