Tail light grommets..

[Sccritterkiller]

After 8 years they final broke anybody know the part number for 2010?...its the plastic inserts the hold the tail light assembly in.
TIA
sc

 

[Adieu]

I think it just uses torx or hex screws I forget which

 

[Sccritterkiller]

I think it just uses torx or hex screws I forget which

Not that side the other side where the prongs on the assembly fit into the body panel there is a plastic grommet that metal prongs fit into...my plastic pieces finally dry rotted so the front of the assembly is rattling around driving crazy...

 

[covertaxn]

I’m looking for these too

 

[rexster314]

I used that SUGRU stuff to fill in the holes, then drilled them out to size them to the alignment pins on the tail light assembly. It was a make do thing at the time that's worked very well

 

[covertaxn]

This may be them:

https://www.amazon.com/dp/B004E6A1XW/ref=cm_sw_r_sms_c_api_satLBbT9Y6TJ5

 

[99WhiteC5Coupe]

After 8 years they final broke anybody know the part number for 2010?...its the plastic inserts the hold the tail light assembly in.
TIA
sc

Did you try the part’s department of a Ford dealer?

 

[Frank Wilson]

Bump. Anybody figure this part out?