What fun little mods would you start off with as a noob?

[NewbieVet]

what tools will I need, cause I don't have any lol.

 

[panda24619]

basics. screw drivers, socket set. i think in the distrustions it will tell you.

 

[NewbieVet]

the distrustions

You got that right!

 

[tallsville]

go easy on panda. he got a california edumacation. if its more complicated then lol or omg they don't teach it here. but if i remember correctly you dont need anything more than a screwdriver and a socket set. you can pick a up a cheap one at lowes or home depot for around $20. i keep a small cheap set in my truck just in case.

 

[panda24619]

go easy on panda. he got a california edumacation. if its more complicated then lol or omg they don't teach it here. but if i remember correctly you dont need anything more than a screwdriver and a socket set. you can pick a up a cheap one at lowes or home depot for around $20. i keep a small cheap set in my truck just in case.

dam straight! haha yeah just a basic socket and screw drive set. do you have a cai talls? or just the exhaust?

 

[tallsville]

both

 

[panda24619]

i knew you had that spintech, but i didnt know you have the cai. now i do! see black. they rnt that hard to do. even talls did his. and hes old...er than me. haha

 

[walnuts4x4]

yeah a K&N is very straight forward with minimal tools... my wife put one on my old silverado.... but that would be a easy first DIY then get some HIDs

 

[NewbieVet]

OK the CAI it is then!!! Who's gunna be my backup in case shit hits the fan???

 

[walnuts4x4]

i'll help as much as I can... but remember I am on vacation... lol... but take your time... lay out all the new stuff and make sure you have everything before you start and highlite the directions as you complete each step.... very easy to do just take your time

 

[NewbieVet]

i'll help as much as I can... but remember I am on vacation... lol... but take your time... lay out all the new stuff and make sure you have everything before you start and highlite the directions as you complete each step.... very easy to do just take your time

I once tried installing a toilet paper holder in my downstairs bathroom. Ended up losing the wall....this ain't gunna' be pretty but fugit I gotta' start somewhere right?

 

[walnuts4x4]

as i said.... lay all parts out and make sure you have and know what each piece is and then follow the directions and mark off each step... and make sure when your installing it only hand tighten each bolt until it is all the way on and after it is aligned tighten everything down

 

[panda24619]

if your mssing a part call k&n and they will send you the part in about 2 days. i herd thats what they do. they have great customer service.