2006 expo

[bigred-262002]

I tested both of them before an if I read it right the sensors should be reading between 250 ohms an 325 ohms. I got 299 ohms on both. Your saying test them again an see if I'm getting any type of change in the hertz while it's running or turning over? Now on this type of system should I or shouldn't I be getting some type voltage AC or DC going to the sensors coming from the PCM?

 

[stamp11127]

You need to verify an output signal from the sensor. Where are you getting the resistance specs from?

 

[bigred-262002]

I Googled it an read that if you test the 2 prongs it should read between 250 olms an 350 an it read 299. How would I test the output?

 

[stamp11127]

PM me your email address