edcp
Member
Here is how I made my Auto lights come on earlier and when it is not so sunny out!
1. Pry the sensor from dash with small screw driver.
2. Remove 2 screws holding board to trim piece.
3. With a black dry erace marker (This can be removed later if needed to adjust) Black out the area that will be above the sensor.(NOT RED LED) I used a small amount to start and it works great! .
4. Easier then putting a paper punch out in sensor!
Ed
1. Pry the sensor from dash with small screw driver.
2. Remove 2 screws holding board to trim piece.
3. With a black dry erace marker (This can be removed later if needed to adjust) Black out the area that will be above the sensor.(NOT RED LED) I used a small amount to start and it works great! .
4. Easier then putting a paper punch out in sensor!
Ed
