Dragging brakes

[k_aimone]

So I did a full break job about a month ago. When I went to start I noticed the front drivers wheel was tough to turn. Once I removed the wheel I couldn't get the caliper off of the rotor. I figured it was a problem with either the caliper or the hose, so I changed both, did all the pads, four rotors, and a fluid change.

Fast foward to today. I went to have the new tires installed and the same problem. The caliper is still holding some pressure. So much so that there is evidence of overheating on the rotor and caliper. I don't swapping out the parts again, which I will do and a wheel bearing, but I can't think of what is causing the issue. Could it be a master cylinder?

The truck is an 05 2wd.

If you have any ideas please chime in.

Thanks in advance.
Ken

 

[69Hcode]

I had a Taurus SHO with dragging brakes. Turned out to be the rubber lines to the calipers swelling up inside. The looked fine on the outside but kept some pressure on the pads. Crack the bleeder and see if there is pressure in there.

 

[k_aimone]

I had a Taurus SHO with dragging brakes. Turned out to be the rubber lines to the calipers swelling up inside. The looked fine on the outside but kept some pressure on the pads. Crack the bleeder and see if there is pressure in there.

Ok I will try that, but the brake hose and caliper are brand new.

 

[k_aimone]

Anybody"

 

[stamp11127]

Did you clean and regrease the caliper guide pins?

 

[Stanger4Life]

Did you clean and regrease the caliper guide pins?

I would also check to make sure everything is lubed up, cleaned prior to lubing it up a gain. Make sure to use silicon.

 

[k_aimone]

Yep everything is lubed. When you try to depress the caliper it won't budge.

 

[stamp11127]

Before swapping out the bad caliper, change the brake fluid in all four calipers. That way once you install the new caliper you will not be filling it with dirty brake fluid.

 

[k_aimone]

Stamp

When I installed the caliper and hose last time I did a full bleed. I have a motive power bleeder, and pushed fluid threw until it was clear.

 

[stamp11127]

Fluid change before or after the caliper replacement? If it was after, you pushed dirty fluid through a new caliper. Many have done it without problems and some have had issues.

 

[2004XLT]

Where is the replacement caliper from? I'd bet money the rep is bad, especially if it's remanufactured. They've been hit or miss for me.

 

[k_aimone]

I got it from carquest. I will just try to swap it again and see what happens.

 

[emtmark]

My left front moans at me from time to time , I'm planning on re greasing the pins the next tire rotation


Sent from my iPhone using Tapatalk

 

[k_aimone]

Where is the replacement caliper from? I'd bet money the rep is bad, especially if it's remanufactured. They've been hit or miss for me.

well you were righ, the car quest caliper failed. I'm thankful I got everything from carquest and advance. I really didn't want to keep the pads, so since I got the caliper from carquest, advance was able to give me new pads. Thanks for the help everyone.