acolic
Full Access Members
Are you saying that the front end from a Gen 2 or 3 is a straight bolt on for a Gen 1?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Are you saying that the front end from a Gen 2 or 3 is a straight bolt on for a Gen 1?
Sent from my iPhone using Tapatalk
I added some LED strip lights under the hood.
Super bright. I'm a little concerned about how well the provided foam double sided sticky tape will hold up to the heat being located right above the radiator. I guess time will tell.
But I need to figure out a switch. I thought I was being smart by tapping into the power for the factory underhood light- but the strip lights remained on with the hood shut. I didn't notice until I was shutting the hood that the factory light flickers as the hood is closed and I figured there must be a position (angle) based switch in the light housing.
I been on here awhile now 2 years or so and this is the first time I came across your thread Tom.I added some LED strip lights under the hood.
Super bright. I'm a little concerned about how well the provided foam double sided sticky tape will hold up to the heat being located right above the radiator. I guess time will tell.
But I need to figure out a switch. I thought I was being smart by tapping into the power for the factory underhood light- but the strip lights remained on with the hood shut. I didn't notice until I was shutting the hood that the factory light flickers as the hood is closed and I figured there must be a position (angle) based switch in the light housing.