Right Hand High and Low Beams Not Working

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Robs05Expedition

New Member
Joined
Jul 20, 2016
Posts
2
Reaction score
0
Location
Elk Grove
Hey guys and gals,

New here so thanks in advance for any and all help.

I tried searching the forums but didn't come up with the exact issue.

So far I've replaced the Low Beam Light, still no Low or High Beams on the right hand side.

I checked a few fuses and they looked good. I am going to do a continuity test tomorrow.

Any advice is appreciated.
 

Bedrck47

Full Access Members
Joined
Jul 4, 2014
Posts
5,639
Reaction score
659
Location
Elizebethtown, PA
Welcome to the forum
Would be nice to know what year the Expy is.
You say you checked SOME fuses. How did you check them?? Hopefully you used a Volt Meter and checked for voltage into and out of the fuse.
 

Bedrck47

Full Access Members
Joined
Jul 4, 2014
Posts
5,639
Reaction score
659
Location
Elizebethtown, PA
Fuse #23 is for the low beam passenger side light Check to make sure you have a solid ground connection for the passenger side lights . The ground wire should be located RH side on radiator

Other fuse to check #5, #20, #40 and #23. USE A METER not just looking at them
 
OP
OP
R

Robs05Expedition

New Member
Joined
Jul 20, 2016
Posts
2
Reaction score
0
Location
Elk Grove
Yep, sorry... 2005 Eddie Bauer edition.

After checking:

• the fuses with a volt meter.
• the ground wire.
• the high and low bulbs, taking them out and putting them back in.

I found the culprit to be the connector.

Thank you for all the tips.
 
Top