Headlight issue

[04BlueBeast]

I have a 2004 Eddie Bauer and my passenger headlight (low & high) does not come on but the Side mark does? Driver side works perfectly. Both bulbs are good. Any suggestions on what to check on?

 

[bedrck46]

The following was copied from the 2004 Owners Manual

Check the following
Fuse #23 10A* RH low beam
Fuse #25 10A* LH low beam
Fuse #35 20A* Instrument cluster high beam
indicator, High beam headlamps

Fuse #40 20A* DRL relays, DRL foglamps, DRL
headlamp relay coil, Headlamp
switch (headlamps), Multifunction
switch (flash-to-pass), BSM
(autolamp headlamps relay), High
beam relay coil, Fuse 25 (LH low
beam), Fuse 23 (RH low beam)

Relay# R03 Hi-beam relay Fuse # 35, Hi-beam headlamps,
Hi-beam indicator

 

[04BlueBeast]

Thank you for the help.

 

[bedrck46]

did it solve the problem

 

[04BlueBeast]

Unfortunately no it didn't still have the issue.
All fuses were good and relay too.

It's only the low and high beam?
Could it be both sockets are bad?

My reverse light on my driver side socket is bad had water in light.
Order new socket.

 

[bedrck46]

see attached print
Also sent you a PM

 

[stamp11127]

Does your high beam indicator work on high beam? If so that means you have power at that part of the circuit. Both high and low beams for the right side share the same ground which would mean you have a complete circuit. If not check the socket with a test light or dvm for voltage.

How did you test the fuses and relay?

 

[metaldrgn]

Is the connector connected to the headlight? Check it with a volt meter. To see if you are getting power. Could have severed wires or a connector disconnected (a mid disconnect, not the one on the light) if the fuses and relays are good.

 

[04BlueBeast]

Thank you again. I'll look into it.

 

[04BlueBeast]

The high beam and low beam work on the driver side and yes the indicator comes on in the dash. The low and high beam do not come on only on the passenger side. Bulbs are good side marker comes on and blinker works. I'm going to test all connectors.

Thank you for your post.

 

[04BlueBeast]

I will test everything this weekend. Thanks for your post.

 

[CJMG]

I am having the same problem. Did you ever figure out what your problem was. Thanks

 

[1955moose]

CJ, start a new post. This post is a most 5 years old. I don't see this guy posting at all these days. Post in either electrical or whatever year you have. 2004 is 2nd edition. As to your question though, it's usually a fuse.

Sent from my N9131 using Tapatalk