Vinyl wrap tail light edges

[J Ski]

what do you think

 

[J_82]

Don’t know what to think. They don’t look bad though.

 

[B-McD]

White or silver are the only colors that would look good against. DIY?

 

[J Ski]

White or silver are the only colors that would look good against. DIY?

Yeah, I’m going to be painting the edges for final product bc I had to use 8 different cut outs of vinyl to get tht look. Too time consuming and paint will last longer

 

[J Ski]

Went with rustoleum lens tint. Tape off, scuff with green scotch bright pad, 3 coats with 10-15 minutes between drying. Here is each coat and then finished product. Still drying so not back on truck yet

 

[B-McD]

Lens tint paint - who knew? Looks good.

 

[Carl H]

Definitely makes the lights look a little more high-end. May have to do this to the wife's Magnetic EL.

 

[J Ski]

 

[J Ski]

 

[JExpedition07]

Looks great

 

[Knox GSL]

SOLD!

 

[ExpeditionAndy]

@J Ski That looks pretty good. I went with the chrome trim but that would have definitely been a way to go if I had thought about it.

 

[J Ski]

@J Ski That looks pretty good. I went with the chrome trim but that would have definitely been a way to go if I had thought about it.

It’s not perfect, I may tape them off, scuff them again, and get one or two more coats on it. My 4 year old decided to touch the edge of one so the finish isnt smooth and there’s a small run on the edge of another that I’m guessing was from the paint pooling up while drying. Good enough for a daily driver though!

 

[Savannah Dan]

You did an excellent taping job. That's the hardest part.