2016 Remote Start Dealer Installed

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

lbv150

Full Access Members
Joined
Mar 12, 2011
Posts
606
Reaction score
284
Location
Northeast
I believe this is a series 100 dealer installed at new vehicle purchase. Dealer not very helpful. Two questions...1: the factory default setting is 10 min. can it be changed to 15 min and how? 2: Can the system keep the engine running with some button presses and then the key removed when you stop at a destination? Or do you have to restart remotely? Thanks
 
Last edited:

ManUpOrShutUp

Full Access Members
Joined
Mar 27, 2016
Posts
2,113
Reaction score
1,157
Location
PA
1. Yes. Instructions here. The remote start system override button should be located somewhere under the dash on the driver side. While you can usually access it from underneath, I have found that it is far, far easier to access by removing the trim panel below the headlight switch. If you have adjustable pedals, it will be the panel with the pedal switch. Just remove the 2 screws holding the trim under the steering wheel. The side trim panel then just pulls off (gently). You should be able to easily access the remote start module from there. Sometimes the button is obscured with electrical tape, but it will easy to find if you can see the remote start module as it's a fairly thick cable running off the box.

2. Once the set time limit is up, the vehicle will shut off. Nothing you can do to stop it.
 
Top