Which clean grill on 2007 Expy (mesh, horizontal, vertical)?

[Ralph Campano]

raptor grill

https://www.4proautoparts.com/shop/ford-expedition-raptor-front-grille-ford-expedition-2007-2014/

 

[tommyddsr]

Are you looking for a clean grill or a Raptor Grill? For a clean grill the mesh looks better.

 

[Ralph Campano]

I really like the Raptor Grill but I am leaning towards blacking out the grill and going with the "Tidewater Tommy-Mesh".

 

[Mark Buckner]

Chrome was starting to peel around the Ford oval on my OEM grill so I bit the bullet on the Raptor-look fro 4Pro. Figured it would look good with my winch bumper. Installed yesterday...




Sent from my iPad using Tapatalk

 

[Ralph Campano]

Raptor Grill looks awesome! Can you post side angle photo and 45 degree photo as well? Also, how did the install go?

 

[Thunderbirdsport]

I'm biased to this one..

(it's mine. The grille is a Stehlen. Got it on amazon. I think they may be out of stock, when I ordered mine back in december there were only a handful left. Think it was around 70 bucks, IIRC..)

 

[Mark Buckner]

Raptor Grill looks awesome! Can you post side angle photo and 45 degree photo as well? Also, how did the install go?

Not 100% sure what you mean by "side angle" but I will give it a go and post some more photos later tonight.

 

[Mark Buckner]

Raptor Grill looks awesome! Can you post side angle photo and 45 degree photo as well? Also, how did the install go?

Here are some more photos, from side and 45°. Closeup shows one minor fit issue, where the fit to the headlight is a bit uneven, wider at the top and tight at the bottom. (Red arrows)

As for the install, it was very easy except that I have the winch bumper. Like the factory grill, this unit is designed to clip to the plastic bumper cover to secure the bottom of the grill. When I put the Iron Bull bumper on, I had to bore holes in the OEM grill, then drill and tap corresponding holes in the bumper and cut some stainless bolts off to squeeze in there. (Third red arrow at the bottom left). Getting those short screws to catch in the threaded hole is a pain in the neck. That took longer than the rest of the install.

I took a bunch of pictures during the install so if there is interest I’ll start a separate thread for that.







Sent from my iPad using Tapatalk

 

[Ralph Campano]

Looks great! Thanks for posting.

 

[Thunderbirdsport]

Nice!