It just happened out of the blue after sitting for one day. Ran fine when I parked it, went to start it the next day and it was running really rough. Scanner shows misfire on cylinder 5,7,and 8. And code p0300. Sometimes it will stall out, Sometimes it will just keep idling rough. . I just...
I assume they did.
I assume they did. I'm real confused now, every part that I have replaced on this engine has been for a 2005. If this one is a 2007 or 08 I wonder what that's gonna affect. Do you know of any way to tell exactly what year this engine is?
I was wondering if I could just change the driver's side and leave the passenger as is.
Oil is good.
You can get a long skinny T 27 in there and loosen the screw but no matter how you turn it you can not get the solenoid out. the hole is too small and the flange where the screw goes stops it...
So I have a 2005 expedition that got a new/remaned engine in it about 20,000 miles ago. Has been nothing but issues since I bought the car. Most recent is CEL on and showing p0020 code. At one time it also showed a p0021 but not anymore. Best I can tell it runs just fine. It first came on while...
I have not washed it but I has been raining nonstop for the past 4 or 5 days and I have been driving all around. I swapped out the 2 coils for new ones. The boots weren't wet but had this whiteish residue on both. Headed home now. Keeping my fingers crossed.
Suppose to be heading back home from the coast today but just had the check engine light come on on the way to the ramp to take the boat out. Engine stumbled and felt like a major misfire but then got better and hasn't done it since. Any help would be appreciated. There are no shops open now and...
It was running a little rough at first. I just change the oil (it smelled like straight gas). And now it seems to run a little better. Cleared the codes and drove around about 10 miles. Don't have any codes showing now. But my scanner is saying the following system monitors are abnormal. Cat...
So I got the plugs, coils, and injectors all replaced. Plugs came right out, no problem. Now It starts right up but I instantly got 2 new codes p2195 and p2198.
02 bank 1 sensor 1 stuck on rich
02 bank 2 sensor 1 stuck on lean
Anyone have any ideas what to do next? Could this be my catalytic...
The other 7 are holding fine. But I decided to bite the bullet and replace all injectors, plugs and coils packs since it has not been done in the time in have owned the car (6 years) and possibly not at all. Everything should be here this weekend. I have all 8 plugs soaking in pb blaster and...
Just replaced the fuel filter and it didn't seem to do anything. Caught the fuel that drained out in a clean container and don't see any water separating. Spark plug wells are dry.
However, after priming (turning the key on and off a few times and pressure still dropping I went under the hood...
Last time I filled up was about 2 weeks ago and have had no issues until Saturday. Have around a half tank right now. I will take a look down in the wells and change the fuel filter this afternoon and report back. I have not noticed any kind of cam phaser noise.
05 expedition 5.4 Triton ~ 160,000
So I was pulling my 10' utility trailer home on Saturday and noticed the car was starting to shake a little bit and losing some power. Then the check engine light started flashing. Tried to limp home but kept losing more and more power then I noticed white...
The air coming out of my main vents and rear vents is not as cold a it use to be. I am hearing what I believe the be the rear txv hissing as the compressor cycles on and off. I just got a set of manifold gauges from O'Riley's loaner tool program, here are my readings.
Ambient - 70°
Static system...
I can not figure out how to adjust my pushrod. There is no 7mm nut to loosen and the whole rod just spins. The brake pedal travels 1.5" before engaging brakes.
I have just started noticing that when my expedition shifts out of 1st gear it loses power. It's like it settles into the gear, rpms drop and it will barely accelerate. It is much more pronunced when going up a steep hill. All other gears shift smoothly and have no issues. 05 EB 4x4 130,000...
I ordered a new brake booster for my 05 expedition and it came with a check valve that looks different than the one I have now. The old one has 3 hoses that connect and the new one only has a spot for one. I ordered the booster from advance and it said it was an exact fit for my car. I would...
My 05 expedition had started running a little rough, mainly just when taking off it will bog down. It is showing 4 faults:
P 0011 camshaft position actuator A bank 1 timing over advanced
P0340 camshaft position sensor A bank 1 circuit malfunctiong
P0344 camshaft position sensor A bank 1 CKT...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.