Well no good deed goes unpunished. After considerable effort trying to get access to the factory bulbs - and a trip to the hardware to get a tool to remove a plastic retaining clip holding the wheel liner firmly in place -I find out that the bulbs that were sent to me apparently are backwards from what they should be.
I removed the factory low beam and then pulled the new LED low beam out of the box and after working to get the ends matched up, I find out it will not plug-in at all. Arrrgh!!!
When I looked closer at the plugs I noticed they are not the same. See the first picture.
The bulbs from ALLA that were marked ‘low beam’ have a plug-in that matches the factory high beam bulb and vice versa. Has anyone else experienced this? See the second picture. In that second pic, you can see that although the plug end matches the factory Low Beam bulb, the tag on the new bulb says High Beam.
Advice?