What did you do to the expy today

[scoot0073]

Pics?

I will tomorrow .
The only tools needed is a Sawsaw and a 2lb hammer..lol

Sent from my Nexus 6P using Tapatalk

 

[1955moose]

I know you guys are going to hate me, but San Francisco hit over 73 degrees today! Went to right outside ocean beach about 4:00 pm, had to put on sun block! You guys have got to go west young men!

Sent from my N9131 using Tapatalk

 

[USMCBuckWild]

I wonder if that's what wrong with mine.
The heated driver seat use to work good, now it's getting slower to heat up. Idk about the passenger seat as it never gets used.

Sent from my Nexus 6P using Tapatalk

It is easy to verify. The control unit for both seats is under the passenger seat. Pull the seat as far forward as it goes, the controller is a 3”x5.5” box that is mounted vertically on the back of the plastic piece that sticks down under the seat. It has 3 connectors (2 of them are small and have separate locks on them), the LARGE connector is the one in question. Disconnect it look at the pins/females, pin “M” is the ground (its M designator is cast into the controller). The pin directly next to it (empty in the pigtail) is the one that you add a female pin to and then splice into the ground wire coming from M.

 

[scoot0073]

Here my Rig sits after the 2" Wheel spacers

Sent from my Nexus 6P using Tapatalk

 

[scoot0073]

Still gotta get that Tan trim painted Black

Sent from my Nexus 6P using Tapatalk

 

[Justinsteg]

Here my Rig sits after the 2" Wheel spacers

Sent from my Nexus 6P using Tapatalk

Scoot, how do you like those RBP tires?

 

[scoot0073]

Scoot, how do you like those RBP tires?

No complaints I'd buy them again fo sure.
And they do real good in mud pits where the mud water comes in ya doors .hahaha

Sent from my Nexus 6P using Tapatalk

 

[J Ski]

Installed JLT Performance passenger side oil catch can

 

[J Ski]

Here my Rig sits after the 2" Wheel spacers

Sent from my Nexus 6P using Tapatalk

Looks hilarious with those skinny ass tires bro. Definitely a buck-tooth bob job

 

[ExpeditionAndy]

Here my Rig sits after the 2" Wheel spacers

Sent from my Nexus 6P using Tapatalk

Would love to see a side view. Where did have to cut the wheel wells.